Panel Communication Failure

Receiving a communication failure or radio not responding message on your panel? This means your system is not communicating with our Alarm Response Center and we won't receive signals for any alarm activity until communication is restored. Below are possible causes as to why your system is showing a communication failure, as well as some tips on fixing the cause.

Power Outage

  • • Make sure your alarm system has power. If you are experiencing a prolonged power outage, the system will come back up when power is restored.
  • • If your power has recently been out, the panel battery may be too weak to allow your cell to send signals. Allow 24 hours to recharge the battery.

Loss of Connection to Power Source

  • • Make sure your plug is connected securely to its outlet.
  • • Make sure the outlet is supplying power—you can check this by plugging something else in to this outlet to see if it's receiving power.

Signal Interference

  • • Large metal objects and appliances that generate radio frequency can interfere with signaling. If you identify these objects around your alarm system, try increasing their distance from your system if it’s safe to do so.
  • • It’s best if your system is located near an exterior wall, above ground (not in a basement), and not in the middle of a large structure (like an interior closet far from exterior walls.)

System Malfunction

If your communication failure is caused by a system malfunction, you can try to power cycle the system:

  • • Completely power down the panel and the module
  • • Wait 2 minutes, then power the panel back up
  • • Test your system to confirm whether communication has been restored. Remember to place the system on test to avoid a false alarm. Click here for steps on how to place your system on test.

Cell Provider Outage

  • If there’s an interruption of cell service in your area, your system’s communication could be impacted.

Interruption to Phone Service (Landline Communication)

  • • Phone service outage in your area.
  • • You have disconnected your home phone service.
  • • You have switched to a new provider.
  • • VoIP and Digital Voice Over Cable may not be compatible with your security system. You may need to switch to a different phone service, or text us to upgrade to cell communication. With cell communication, you get access to remote arming and disarming from your phone. You also open the door to transform your home with smart automation devices like remote cameras, thermostats, lights, and door locks.
  • • Your new provider may not have connected your phone line to your system.

Power Cycle Your Panel

Follow the below instructions to power cycle on yourr 2GIG GoControl Panel:

1. Disarm the system with your Master or User Code, then unplug the power supply.

GC_Transformer_2.jpg

2. Remove the top screw on top of the GoControl panel, and pry open the slots with a screwdriver.

2GIG_GC2_Screw_Top.jpg

3. Gently pull the front cover down, and hang it from the plastic strap on the back plate.

GC2_Hang_From_Strap.jpg

4. Unplug the battery cable from the circuit board, then plug back in.

GC2_Replace_Battery.jpg

5. Reassemble the touchscreen, and plug in the power supply.

GoControl_Small.jpg

Still having trouble?

  • If communication failure continues, text us at BRINKS for help.

Chat