IQ Panel 2 - Add Z-Wave Device
1. Press or swipe down clock display at top for Settings Tray, then press SETTINGS
2. Press ADVANCED SETTINGS, then enter Installer Code 1111
3. Press INSTALLATION, then DEVICES
4. Press ADD DEVICE, then PAIR
5. IQ Panel 2 enters Z-Wave learn mode
GE Jasco Plug-in Lamp Appliance Module
Double Click Mate button
Qolsys IQ Siren
Press button at bottom of siren
GE Jasco Wall Dimmer Light Switch
Turn light switch on and off
GE Jasco Wall AC Outlet
Double click button in the middle of outlet
Schlage Deadbolt Door Lock
1. Enter 6-digit programming code provided in the Schlage documentation
2. Press the SCHLAGE logo or button, then 0
Kwikset Deadbolt Door Lock
Open battery compartment cover, press left SmartCode button, then wait 2 minutes
Yale Touchscreen Deadbolt Door Lock
1. Touch screen with the back of your hand or fingers to activate
2. Enter 8-digit Master PIN Code, then press - lock should sound happy tone
3. Press 7 then - lock should sound happy tone
4. Press 1 then - lock should sound happy tone and exit
2GIG GoControl TBZ-48
1. Hold FAN button for 5 seconds until SETUP, then press UP ARROW button until ZWAVE
2. Press MODE button to select, then press MODE button again to learn
3. If successful press FAN button to exit, antenna icon appears by temperature display
Alarm.com ADC-T2000 Thermostat
1. Press MODE button to display temperature, press MODE until heat/cool icons disappear
2. Hold DOWN ARROW until Radio Wave Icon appears below temperature display
Alarm.com ADC-T3000 Thermostat
1. Press MENU button to display Menu then press DOWN ARROW until SETTINGS
2. Press ENTER button to select then press DOWN ARROW until NETWORK
3. Press ENTER button to select then press UP or DOWN ARROW to highlight ADD
4. Press ENTER button to select and start Z-Wave learn mode
5. Learning may take up to 1 minute to complete and exit
Honeywell T6 Thermostat
1. Press Menu then press right arrow until Z-Wave Setup then press Select
2. Press Select at the Include screen to learn
Honeywell 8320Z1000 Thermostat
1. Press SYSTEM then hold bottom buttons together until screen changes
2. Press Arrow buttons until "rF20" then press Arrow buttons to change 0 to 1
3. Thermostat enters Z-Wave enrollment, when finished press DONE to exit
Radio Thermostat CT-20 and GE Thermostat
Pull top cover toward you to remove then press MATE button to learn
Radio Thermostat CT30, CT100, CT101
1. At thermostat press MENU button, "r1" displays and MATE appears under antenna icon
2. Press MATE, which begins flashing, if successful LINK appears, press MENU to exit
Radio Thermostat CT110
Press left side Antenna button
Trane TZ43 / TZ45 Thermostat
1. Press MENU button then press Scroll Down button to ZWave Install then press SELECT
2. Press Scroll Up button for Yes to start Z-Wave enrollment
3. If successful display exits to main menu, press DONE button to exit
Linear GD00Z Garage Door Controller
Press the Mate button, controller sounds 1 beep then 3 beeps if successful
6. If successful IQ Panel 2 displays device settings, press NAME then select name
7. Press ADD then HOME to exit