Lynx Plus - System or Sensor Trouble

1. Lynx Plus beeps rapidly when a trouble exists, press * STATUS to view

Lynx_Plus_Trouble_1.jpg

2. Enter User Code then press DISARM to reset, trouble will not reset until trouble ends

Lynx_Plus_Disarm.jpg

Possible troubles

  • bF = Not communicating with cellular module
  • CC = Remote access or download in progress, this is not a trouble
  • Check 01 to 41 = Sensor supervisory trouble, tamper or failure
  • Comm Fail = Failure to communicate to Brinks Home Security
  • d1 = Standby Panel powering up or disabled by downloading
  • EA = Exit Alarm Door was left open after arming, this is not a trouble
  • Fault 01 to 41 = Sensor open, this is not a trouble
  • Fault 90 = RF Jam or interference
  • Fault 103 = Not communicating with cellular module
  • FC = Fail to communicate to Brinks Home Security
  • Low Bat = Panel low battery
  • Low Bat 00 = Wireless keypad low battery
  • Low Bat = 00 to 41 Wireless sensor low battery
  • Msg = Voice message has been recorde, this is not a trouble
  • Modem Comm = Remote access or download in progress, this is not a trouble
  • NO AC = AC power failure