GC3 GoControl - Programming A Door / Window Sensor
1. Press SYSTEM SETTINGS then enter Installer Code 1561 then press INSTALLER TOOLBOX
2. Press SYSTEM CONFIGURATION then press WIRELESS ZONES then select Wireless Zone 001 to 100 on the left then press EDIT ZONE
3. Press SENSOR TYPE then press to choose from the list of all Sensor Types
4. If Sensor Type 04, 06, 07, 08, 10, or 23 was selected enter Sensor Equipment Type
5. Press EQUIPMENT CODE then press to choose from list of all Equipment Codes
6. Press SERIAL NUMBER then enter serial number or press LEARN button then activate sensor then press ACCEPT to finish
7. If enabled press SMART AREAS then select which partition 1 to 4 sensor has access
8. Press EQUIPMENT AGE then select if New or Used (for reference only and doesn't affect anything)
9. Press SENSOR LOOP then select loop number
10. Press TRANSMISSION DELAY and set to enable or disable (time is set in Q39)
11. Press VOICE DESCRIPTOR then EDIT VOICE DESCRIPTOR, enter 1st letter of word then select word (up to 6) from list then press DONE to finish
12. Press SENSOR REPORTS then select enable or disable
13. Press SENSOR SUPERVISED then select enable or disable (Leave on for all but Panics)
14. Press SENSOR CHIME then select from the list then press NEXT ZONE for next sensor or RETURN TO SYSTEM CONFIGURATION to exit