How to Fix Panel Communication Failure on the IQ Panel 2

Receiving a communication failure or radio not responding message on your panel?

This means your system is not communicating with our Alarm Response Center and we won't receive signals for any alarm activity until communication is restored.

Below are possible causes as to why your system is showing a communication failure, as well as some tips on fixing the cause.

Power Outage

    • Make sure your alarm system has power. If you are experiencing a prolonged power outage, the system will come back up when power is restored.
    • If your power has recently been out, the panel battery may be too weak to allow your cell to send signals. Allow 24 hours to recharge the battery.

Loss of Connection to Power Source

    • Make sure your plug is connected securely to its outlet
    • Make sure the outlet is supplying power - you can check this by plugging something else in to this outlet to see if it's receiving power

Signal Interference

    • Large metal objects and appliances that generate radio frequency can interfere with signaling. If you identify these objects around your alarm system, try increasing their distance from your system if it’s safe to do so.
    • It’s best if your system is located near an exterior wall, above ground (not in a basement), and not in the middle of a large structure (like an interior closet far from exterior walls)

System Malfunction

      • If your communication failure is caused by a system malfunction, you can try to power cycle the system:
        1. Completely power down the panel and the module
        2. Wait 2 minutes, then power the panel back up
        3. Test your system to confirm whether communication has been restored (remember to place the system on test to avoid a false alarm)

Cell Provider Outage

        • If there is an interruption of cell service in your area, your system’s communication could be impacted.

        Interruption to Phone Service (Landline Communication)

      • Phone service outage in your area
      • You have disconnected your home phone service
      • You have switched to a new provider
          • VoIP and Digital Voice Over Cable may not be compatible with your security system. You may need to switch to a different phone service, or text us to upgrade to cell communication. With cell communication, you get access to remote arming and disarming from your phone. You also open the door to transform your home with smart automation devices like remote cameras, thermostats, lights, and door locks.
          • Your new provider may not have connected your phone line to your system.

          Still having trouble?

          See below to review steps to power cycle your IQ Panel 2. If communication failure continues, text us at 469.513.8685 for help.

          1. Press or swipe down clock display at top for Settings Menu then press SETTINGS

          Enter_Program_01_Main.jpg Enter_Program_02_Dropdown.jpg

          2. Press ADVANCED SETTINGS then enter Master Code

          Enter_Program_03_Settings_Menu.jpg Enter_Program_04_Enter_Code.jpg

          3. Press POWER DOWN, then press OK to confirm and power down

          Power_Down_01.jpg Power_Down_02.jpg

          4. Wait 2 minutes, then press right side power button for 3 to 4 seconds to power up

          IQ2_Side_Power_Button.jpg