2GIG Edge - Programming a Door/Window Sensor

Please follow the steps below to program new door/window sensors into the 2GIG Edge panel:

1. Tap the settings ( 0000_cog.png ) icon and enter your installer code (1561)

2. Scroll to the bottom of the screen to access the Installer Toolbox

003.png

3. Select Panel Programming, then Wireless Zones

004a.png 004.png

4. Tap the Zone Number you would like to assign the wireless sensor, then tap the Edit Zone button in the lower right corner of the screen

004.png

5. Select the appropriate Equipment Code for this sensor by tapping the Menu icon, then choose from the dropdown list

0006.png

Referenced below are the door and window contacts most common to this system:

2GIG eSeries Thin Door/Window Contact

2862

2GIG eSeries Recessed Door Contact

2863

6. Press the down arrow to continue, then select the Sensor Type by tapping the Menu icon again. Choose the sensor type from the dropdown menu.

007.png

7. Press the down arrow to continue, then input the TXID number (located on the sensor sticker) using the keypad

008.png

8. Press the down arrow to continue, then select Loop 1 for Door/Window sensors

009.png

9. Press the down arrow to continue, then tap Add Voice Descriptor. Type the first few letters of the descriptor and select from the list that populates.

010a.png010b.png

10. Tap Done, then press the down arrow to continue and select the desired Chime for the sensor

011a.png

11. Press the down arrow to continue, and select the assigned Smart Area from the list

012.png

12. Press the down arrow to continue, and choose whether to enable to disable delayed transmission

013.png

��

13. Press the down arrow to continue, and choose whether to enable or disable Sensor Reports

014.png

14. Press the down arrow to continue, and choose whether to enable to disable Sensor Supervised monitoring

015.png

15. Press the down arrow to continue, and tap the back button until you return to the home screen to save all changes


Chat