How to Remove a Z-Wave Device from the Lynx Touch
1. Press Automation, then Tools.
2. Press Exclude Devices, then enable Z-Wave delete mode on your device.
3. As the system enters Z-Wave exclusion mode, trigger the sensor you want the system to learn. Steps for triggering common sensors are shown below. To skip to the final step, click here.
GE Jasco Light Appliance Module Double click the Mate/Learn button. GE Jasco Wall Dimmer Light Switch Turn light switch on and off. GE Jasco Wall AC Outlet Double click button in middle of outlet. Schlage Lever Lock or Deadbolt 1. Enter 6-digit programming code provided in documentation from Schlage. 2. Press Schlage logo or button, press 0, then wait 2 minutes to learn. Kwikset Deadbolt Open battery cover, press left SmartCode button then wait 2 minutes to learn. Yale Touchscreen Deadbolt: Alarm.com ADC-T2000 Thermostat 1. Press Mode to display temperature, then Mode until heat/cool icons disappear. 2. Hold Down Arrow until the radio wave icon appears below the temperature display. Honeywell T6 Thermostat 1. Press Menu, press the right arrow to Z-Wave Setup, then press Select. 2. Press Select at the Include screen to learn. Radio Thermostat CT-20 and GE Thermostat Radio Thermostat CT30, CT100, CT101 1. On the thermostat, press Menu. The screen will display r1 and Mate appears under the antenna icon. 2. Press Mate, which begins flashing. If successful, Link appears, then press Menu to exit. Radio Thermostat CT110 Press the left side antenna button. Linear GoControl Garage Door Controller Press the side Mate button, controller flashes then sounds 1 beep followed by 3 beeps. Final Panel Instructions 4. If successful the Lynx Touch beeps. Press the back arrow or Home to exit.
Pull top cover toward you to remove, then press Mate to remove.
