Honeywell 5800PIR-RES—Battery Replacement

When it is time to replace the battery in your Honeywell 5800PIR-RES motion detector, you will see an alert on your system panel, as well as a notification in the Brinks Home™ Mobile App.

Follow the instructions below to replace your battery and clear the alert from your system. The Honeywell 5800PIR-RES motion detector requires a CR123A 3-volt lithium battery, which can be purchased at your local hardware, mass retailer, or battery store. You may also order these online here or at your preferred online retailer.

Step-by-Step Instructions:

1. Press the bottom tab to remove the front cover.

001 5800PIR-RES Open

2. Remove and replace the CR123A 3-volt lithium battery.

002 5800PIR-RES Batteries

3. Return the cover to the sensor, starting with the side opposite the bottom tab, pressing closed until the tab snaps into place.

003 5800PIR-RES Restore Cover

4. Check if the low battery status has cleared or go to the following link for further instructions on clearing the error from the panel memory: GC2 GoControl - Silence Reset Alarm.