Honeywell 5800COMBO—Battery Replacement

When it is time to replace the battery in your Honeywell 5800COMBO smoke/carbon monoxide detector, you will see an alert on your system panel, as well as a notification in the Brinks Home™ Mobile App.

Follow the instructions below to replace your battery and clear the alert from your system. The Honeywell 5800COMBO smoke/carbon monoxide detector requires 4 CR123A 3-volt lithium batteries, which can be purchased at your local hardware, mass retailer, or battery store. You may also order these online here or at your preferred online retailer.


Step-by-Step Instructions:

1. Turn the sensor counter-clockwise to remove from baseplate.

0001 5800COMBO Remove from baseplate


2. Remove and replace 4 CR123A 3-volt lithium batteries.

0002 5800COMBO Batteries


3. Align the sensor over the baseplate, and turn clockwise while pressing against the baseplate to reinstall.

0003 5800COMBO Reinstall


4. Check if the low battery status has cleared or go to the following link for further instructions on clearing the error from the panel memory: GC2 GoControl - Silence Reset Alarm.