GC2 GoControl—Sensor Information
2GIG-RPTR1-345 Wireless Repeater
Specifications
- Repeats 345 MHz 2GIG and Honeywell sensors
- 24-hour backup battery
- RF Range 100' from panel or wireless sensors
- Operating temperature 14°F to 131°F
- 14-Volt 1700 mA DC power supply
- 14500 3.7-Volt 800 mA Lithium battery (up to 24-hour backup)
Panel Compatibility
- 2GIG GC2 Go Control v1.16 and higher
- 2GIG GC2e
- 2GIG GC3 v3.1 and higher
- 2GIG GC3e
Sensor Compatibility
- Compatible with most 245 MHz 2GIG and Honeywell wireless sensors
- Not compatible with 2GIG TS-1 Touchscreen
Status LED
- Green ON = Power and battery OK
- Red ON = Tamper or power failure
- Red slow flash = Low battery
- Red fast flash = RF Jamming
- Blink OFF = Transmission received
2GIG-SDS1-345 Smoke Detector
Specifications
- Only 1 sensor is needed on interconnected smoke detectors
- Sends Smoke Alarm + SDS1-345 Low Battery, Tamper/Supervisory messages
- 345 MHz sends supervisory signal every 70 minutes
- Operating temperature 40°F to 100°F
- CR2032 3-Volt Lithium battery, up to 3 year estimated battery life
- 7-day battery life if AC power fails
Panel Compatibility
- 2GIG GC2 Go Control
- 2GIG GC2e
- 2GIG GC3
- 2GIG GC3e
2GIG-TS-1 Secondary Touchscreen
Specifications
- 4 touchscreens per system
- Display is identical to Go Control panel
- 918.872 MHz (Zigbee) requires 2GIG-XCVR2-345 Bi-directional transceiver module
- OTA firmware updates from Alarm.com website will update both Go Control and TS-1
- Local updates require 2GIG USB CABLE with pins to update TS1
- RF Range up to 100' from panel
- Operating temperature 32°F to 120°F
- 9 to 14-Volt 2GIG-AC1 DC power supply
- TS-1 version 1 = 3 AA Alkaline batteries
- TS-1 version 2 = No batteries, plug-in transformer connector
Compatibility
- 2GIG GC2 Go Control v1.8.1 and higher
- 2GIG GC2e
2GIG-TILT1-345 Tilt Sensor
Specifications
- Activates if tilted 45° from vertical
- 5-second delay between activation and panel displaying open zone
- 345 MHz sends a supervisory signal every 70 minutes
- RF Range up to 100' from panel
- Operating temperature 2°F to 120°F
- CR2032 3-Volt Lithium battery, 5 to 8 year estimated battery life
Compatibility
- 2GIG GC2 Go Control v1.14 and higher
- 2GIG GC2e
- 2GIG GC3 v3.1.1 and higher
- 2GIG GC3e
Programming
- Tilt 5 seconds to learn
- Program as a door sensor
- Sensor Type: Entry Exit 1 or Entry Exit 2
- Equipment Code: 1062 2GIG Tilt Sensor
- Loop 1
2GIG-TAKE-345 Superswitch Wireless Converter
Specifications
- Converts 8 hardwire zones 8 2GIG compatible wireless zones
- Receives power from old alarm panel backup battery or power supply
- 2GIG-TAK-KIT1 combines TAKE345 with enclosure and Altronix power supply
- 345 MHz sends a supervisory signal every +7
- RF range up to 100' from panel
- Operating temperature 32°F to 120°F
Compatibility
- 2GIG GC2 Go Control
- 2GIG GC2e
- 2GIG GC3
- 2GIG GC3e
2GIG-STVGRL1-345 Stove and Grill Detector
Specifications
- Notifies if knob on grill or stove is left in ON position
- Non-replaceable internal Lithium, up to 5 year battery life
- RF Range up to 100' from panel
- Operating temperature 14°F to 167°F
Compatibility
- 2GIG GC2 Go Control
- 2GIG GC2e
- 2GIG GC3
- 2GIG GC3e
- Honeywell Lynx
- Honeywell Lyric
- Honeywell Vista
2GIG-SMKT3-345 Smoke Heat Detector
Specifications
- Discontinued replaced by 2GIG SMKT8-345
- Smoke detector with integrated heat and freeze sensors
- 35' protection area
- Freeze detector activates below 41°F
- Heat detector activates above 135°F
- 345 MHz sends supervisory signal every 70 minutes
- Trouble beeps can be silenced for 12 hours with test button
- 3 AAA Alkaline, 2 to 3 year estimated battery life
- 35' detection range
- RF range up to 100' from panel panel
- Operating temperature 40°F to 100°F
Compatibility
- 2GIG GC2 Go Control
- 2GIG GC2e
- 2GIG GC3
- 2GIG GC3e
Testing
- Press and release Test button to test smoke sounder
- Hold Test button 20 seconds to trigger smoke detector test to panel
Status LED
- Normal = Green flash every 12 seconds
- Alarm = Red flash every second, 3-tone sounder
- Dirty Element = Yellow blink every 8 seconds, chirp every 48 seconds
- Trouble = Yellow blink every 4 seconds, chirp every 48 seconds
- Low Battery = Yellow flash every 12 seconds, 1 chirp every 45 seconds
- Freeze = 3 Yellow blinks every 4 seconds
- Tamper = Red, yellow, and green flash every 12 seconds