ADC-SG130 WiFi Gateway Guide
Hardwire connection to Internet Router for up to 4 WiFi cameras
Specifications
- 2.4 GHz, does not support 5 GHz devices
- WiFi 8021.11 b/g/n/ac
- Ethernet connection
- Operating temperature 32° F to 104° F
Factory Default
Insert paperclip into side hole then hold reset button 15 seconds until all lights flash
Camera WiFi Setup by WPS Enrollment
1. Press side WPS button 3 to 5 seconds, WiFi LED slowly flashes
2. Enable WPS mode in camera, usually by holding WPS button 5 seconds
Hardwire Connection to Router
Connect Ethernet cable to ADC-SG130 and unused port on network router
Add Gateway using Customer Website
1. Login on laptop or home computer to Alarm.com customer website and press VIDEO
2. Press SETTINGS
3. Scroll to bottom of page and press ADD VIDEO DEVICE
4. Enter MAC Address found on back of Smart Gateway then press FIND
5. Press NEXT to continue
6. Press NEXT again to continue
7. Alarm.com downloads information to Gateway, this may take 5 to 10 minutes
8. When finished press HOME to exit
