Concord 4 Panel Guide


  • • Input zones: 96 max hardwire or wireless; 8 hardwire zones built in
  • • Operating temperature: 32 to 120°F
  • • Dimensions (H x W x D): 14.0 x 12.0 x 3.0 in.
  • • Installation: wall mount
  • • Backup battery: 12 VDC, 4.5 Ah or 7 Ah rechargeable, sealed, lead-acid

Interlogix Concord 4


  • • Two onboard programmable outputs
  • • SIA CP-01 false alarm reduction standard compliant
  • • 2-wire and 4-wire smoke detector compatibility
  • • Panel auxiliary power provides 1 amp
  • • Built-in 12-watt siren driver

User Functions

Arm Away: arm away is used when you plan on arming the system and leaving the home.

  1. Press 3 (Away), then enter your user code.
  2. Concord_Arm_Away_1.jpg

  3. The keypad beeps 3 times, and the LED next to Armed lights up.
  4. Concord_Arm_Away_2.jpg

Arm Stay: arm stay is used when you plan on arming the system staying home.

  1. Press the 2 (Stay), then enter your user code.
  2. Concord_Arm_Stay_1.jpg

  3. The keypad beeps 2 times, and the LED next to Armed lights up along with a message Armed to Stay displayed.
  4. Concord_Arm_Stay_2.jpg

Disarm System: this will disarm your system, and it will silence and reset any active alarm.

  1. Press 1 (Disarm), then enter your user code.
  2. Concord_Disarm_From_Arm.jpg

  3. The keypad beeps, and the LED next to Armed turns off.
  4. Concord_Keypad_Template.jpg

Check Your System Status: checking your system's status will display which sensors are currently open or if any of your sensors are experiencing a trouble condition, such as a low battery.

  1. Press * (Status).
  2. The system sounds beeps according to the current arming level.
  3. The touchpad will display System is Ok if all sensors are closed; otherwise, it will display the status of sensors not ready.

Check Sensor Status: review a list of sensors connected to your system to ensure all are communicating and trouble free.

If all sensors are closed and system is a ready to arm state, the LED next to Ready will be lit.


If sensors are open, the LED next to Ready will be off; otherwise, depending on your version of the Concord 4, * appears on the display. Press * (Status) to display any open sensors.

Concord_Not_Ready_To_Arm_1.jpg Concord_Not_Ready_To_Arm_2.jpg

How to Power Cycle the Panel

  1. Find the main panel (usually located in a closet). Remove any screws from the cover or unlock to open the cover.
  2. Concord_Battery_Replacement_1.jpg

  3. Unplug from AC power from the wall. If you cannot find the plug for your panel, be careful when disconnecting the 12 Volt 4 to 7 Amp battery, then wait several minutes before reconnecting.
  4. Concord_Battery_Replacement_2.jpg

If you need further assistance, you can text a Support Representative any time at 469.513.8685.

For additional information relating to your device, click the following link to view the original manufacturer's user guide or installation manual: Concord 4 User Manual