Concord - Add Z-Wave Device
This requires an Alarm.com cellular communication module
Hold Z-Wave button on cellular daughter-board until L2 LED flashes 4-blink pattern
GE Jasco Lamp Appliance Module
Double click the Mate button
FortrezZ Indoor Siren
Bring siren within 6 feet of Concord then press Program Switch 2 times to learn
Everspring SE812 Indoor Siren
Bring siren within 6 feet of Concord then press Link button 3 times to learn
GE Jasco Wall Dimmer Light Switch
Turn the light switch on and off
GE Jasco Wall AC Outlet
Double click the button in the middle of the outlet
Schlage Deadbolt Door Lock
1. Enter 6-digit programming code provided in the Schlage documentation
2. Press SCHLAGE button then 0, The Schlage button flashes orange
Kwikset Deadbolt Door Lock
Open the battery cover and press left SmartCode button
Yale Touchscreen Deadbolt
1. Touch screen with the back of your hand or fingers to activate
2. Enter 4 to 8-digit Master Code then press #, lock should sound Happy tone
3. Press 7 then # to learn, lock should sound Happy tone
Alarm.com ADC-T2000 Thermostat
1. Press MODE button to display temperature, press MODE until heat/cool icons disappear
2. Hold DOWN ARROW until Radio Wave Icon appears below temperature display
Alarm.com ADC-T3000 Thermostat
1. Press MENU button to display Menu then press DOWN ARROW until SETTINGS
2. Press ENTER button to select then press DOWN ARROW until NETWORK
3. Press ENTER button to select then press UP or DOWN ARROW to highlight ADD
4. Press ENTER button to select and start Z-Wave learn mode
5. Learning may take up to 1 minute to complete and exit
GE Basic Thermostat
Remove top cover then press the MATE button
Radio Thermostat CT30, CT100 and CT101 Thermostat
1. Press thermostat MENU button, r1 displays and MATE appears under antenna icon
2. Press MATE button again, MATE begins flashing
3. If successful thermostat displays LINK under antenna icon, press MENU button to exit
Radio Thermostat CT110 Thermostat
Press left side Antenna button
GoControl RCS Technologies TBZ-48 Thermostat
1. Hold FAN button 5 seconds until SETUP appears then UP ARROW button until ZWAVE
2. Press MODE button to select then press MODE button again to learn
3. If successful press FAN button to exit, antenna icon appears by temperature display
Trane Thermostat
1. Press MENU button then Scroll Down button to Z-WAVE INSTALL and press SELECT
2. Press Scroll Up button for YES to begin Z-Wave enrollment
3. If successful returns to main menu, press Done button to exit
If successful Concord keypad beeps and L2 LED turns ON for 1 minute