Close
Close
Help Center Simon XTi - Image Sensor Signal Strength

Simon XTi - Image Sensor Signal Strength

1. Press bottom right GEAR icon then press DOWN ARROW several times

Enter_Programming_01_Main.jpg Enter_Programming_02_Settings.jpg

2. Press ENTER by Programming then enter Installer Code 4321 then press OK

Enter_Programming_03_Programming_Enter.jpg Enter_Programming_04_Enter_Code.jpg

3. Press INTERACTIVE SERVICES then press IMAGE SENSOR

Programming_-_Image_Sensor_00.png Programming_-_Image_Sensor_01.png

4. Press STATUS then check signal strength then press CLOSE several times to exit

Programming_-_Image_Sensor_02.png Programming_-_Image_Sensor_03.png

To increase this range:

Programming_-_Image_Sensor_04.png

Programming_-_Image_Sensor_05.png

If you are still not getting over 30% signal verify antenna is placed as displayed below:

Picture11.png

Related Articles

Contact Support