ADC-V510 Indoor Camera Guide

Summary: The ADC-V510 Camera is a reliable indoor camera that supports Ethernet and WiFi connectivity. This guide provides detailed instructions for setting up the camera, resetting it to factory defaults, and troubleshooting common issues.

Specifications

• 640 x 480 pixel video resolution
• 49.6° Horizontal, 38.2° Vertical field of view
• No night vision capability
• WiFi 802.11 b/g
• Ethernet connection
• Operating Temperature: 32°F to 104°F

Factory Reset

Warning: Performing a factory reset will erase all settings, and the camera will need to be re-added to your account.

1. Insert a pin into the reset hole located on the back of the camera.
2. Hold the button for 60 seconds until the front LED flashes red.

Hardwire Connection to Router

Note: An Ethernet connection is required for initial setup and WiFi configuration.

1. Connect an Ethernet cable to the port on the back of the camera.
2. Plug the other end into an available port on your network router.

Add Camera Using the Brinks Home™ App Website

Note: The camera must first be connected to WiFi.

1. Log in to the Brinks Home App on a desktop browser and press Video.
2. Select Settings.
3. Scroll to the bottom and select Add Video Device.
4. The camera should be detected. Enter a name for the camera and select Install.
5. Wait several minutes for the camera to be added to the network.
6. Once complete, select Live View to view images from the camera.

Add Camera Using the Brinks Home™ Mobile App

Note: The camera must first be connected to WiFi.

1. Log in to the Brinks Home Mobile App and press Video (found under the menu icon in the top left corner).
2. Select Settings by pressing the Gear Icon in the upper-right corner.
3. Select Add Video Device, then choose your compatible device type.
4. The camera should be detected. Enter a name for the camera and select Next.
5. The camera may take several minutes to configure.
6. Once complete, select Live View to view images from the camera.

Troubleshooting

• Power cycle the camera by unplugging and plugging in the power adapter.
• Move the camera closer to your WiFi router.
• If issues persist, reset the camera to factory defaults.

LED Reference Guide

• Solid Green: Local network and Internet connection OK.
• Flashing Green: Local network connection OK, Internet connection bad.
• Solid Red: No local network or Internet connection.
• Flashing Red: Camera booting.
• Flashing Blue: Camera in WPS WiFi learn mode.
• Flashing White: Camera in WiFi AP learn mode.
• Flashing Yellow: Camera in Bluetooth pairing mode.